Power is supplied to the track and the locomotive by the power supply, speed controller, terminal wire, and E-Z Track terminal/rerailer. ![]() Power supply and speed control are plug and play no tools are needed.If you detect bumps or distortion on the track surface, recheck the rail joiner fit.After track is assembled, double-check for joint connection and fit by lightly running your fingers over the top of the rails in both directions.This can cause train derailments and electrical circuit interruptions. Be careful that the rail joiners do not slip under the rail without properly connecting. Make sure the rail and joiners are seated properly. Assemble the track by pushing together.If your set does not come with one, magnets are available separately (HO Item No. Install under-track magnet, if your set comes with one.The terminal/rerailer section will later be connected to a power pack and power supply, so place it near an outlet or power strip.To make sure you have enough working room, make a test track layout by loosely placing track in desired configuration. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |